Intelliframe to warp & rev?

[Lord_Whoopass]

I have an intelliframe on my Mag with a warp feed and I was wondering if it would be a good idea to run two sets of wires from the intelliframe and link it up to the warp feed and the revy. my thoughts are that it would make sure that the revy would agitate everytime I shoot and the warp would feed. Just thought I would get a couple of your opinions. :D

[ryannyqst]

I tried it and i had a problem where the rev and the warp would go constantly and would not stop so i think i did something wrong but you could try it if you want

[digitard]

If the revvy and warp are going constantly, did you connect the Intelli wires correctly?

Did you put the roller switch too close to the sear so it was always pressed?

It would work...

**Smiles cause he has a Halo**

Sincerely,
Dave K

[ryannyqst]

I am sure i did something wrong i just havent gone back and tried it again. But i know the switch wasnt to close

[xen_100]

if you are really concerned about it, just use a dual pole switch. then the revy and the warp will have thier own path to ground, but will be isolated when you are not firing.