VL 3000 Internals Query

[Strider]

I have aquired VL 3000 shells, without internals. What internals should I look for? Were they the same as the VL 2000 internals?

Has anyone tried other loader internals in them before? (Ie - Revvy, Shreader)

[CDN_Drew]

for people who have never seen one:
http://www.vm68.com/stuff/pics/vl3000.jpg

The Vl3000 uses the similar if not the same internals as the old VL2000 power series. You won't really be able to fit newer boards in because with these models the battery went in opposite to the way the new ones do and the board was smaller. you might be able to fit a new eye and motor in, i don't think they changed that much.

[LaW]

yeah the vl3000 was just made to hold closer to 300 balls instead of 200 balls.....

[Strider]

Cool, thanks CDN_Drew. Good to hear from a Cancon guy, haven't heard much about them latley... (I do see they've redone the site...)

[paintballbeaver]

you can fit a new board in them i've seen it all you do it leave the board in the on position an then go to radio shack and buy some 9vlt connecter and rap then around the battery connections or if you have the resourses solder it and then youll have a x board vl 3000

[Jaymz]

where do you pick one of these up?

[CDN_Drew]

The loaders are no longer available new. You would need to scoure ebay, pawnshops and palyers getting out of the sport to find one. Having said that they are going to be very hard to find. They were only made for a short time quite a few years ago. I personally only know a few people who have them.

[johnny dee]

im sure that they work just fune and the same as the ond ones, but i think they look hidious...thats all, i had to say that

[Nobody077]

If your using it on a intela frame mag you can just skip the board. I have done this with a pair of revi shells, just wire the negitive battery lead to the servo and the positive battery lead to your intelafeed jack then the other side of the jack to the positive side of the servo. This works good with 1 9v battery if your going to run 2 9v's the use a regulator like use in the Wapr 12v mod

PS I just read in your sig a E-mag dont use this setup with the E-mag intella link it WILL fry it, it should only be used with a micr-switch make/break type of link.

[TheDuelist]

Another thing you can do is use the Empire Reloader kit. I modified my shells to accept the board and servo and it works great with minimal modification. Its activated by sound so with every shot it spins. I have yet to have it fail on my EMag.

[Strider]

Thanks for the tips guys. I wasnt planning on intelilinking it. It was more for fun sake, I'll probably run it on my VM! :D

I've been looking for 5 months now. I happened upon them...