View Full Version : Need Help-RT Valve Question
powermad
03-05-2003, 11:03 PM
I just picked up an RT PRO and I'm not real farmiliar with mags. Here's my problem: The bolt sticks out into the feed tube and will not go back any further. I pulled the valve out and it just will not go far enough down into the power tube to seat. It's got to be sticking out about a 1/4". I'll atach a pic to better demonstrate. I pulled out the power tube spacer, I'll attach a pic of it as well. Any help would be greatly appreciated.
powermad
03-05-2003, 11:04 PM
pic of spacer
maximum
03-05-2003, 11:25 PM
To me it looks like a Level 10 Power tube Tip and Spacer with the Old Lvl 7 Bolt..
- Maximum
powermad
03-05-2003, 11:27 PM
I was just going to say the same thing. After futher inspection it looks like level 10 was installed and stock bolt was put in before I traded for it. Thanks for your help man, I really appreciate it!
maximum
03-05-2003, 11:29 PM
Not a Problem.. Now all you need is the LVL 10 bolt and your set =)
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.