View Full Version : Tippmann 98 bottom line threading
Cristobal
03-06-2003, 02:29 PM
I'm making a drop forward for a tippmann 98c and need to check on the specs for the bottom line attatchment holes in the base of the grip. I think they're threaded 10-32, spaced 3/4" on the centers -- is this right?
ChucktheMAGician
03-06-2003, 02:35 PM
I'm to lazy to go measure it but it's the same size as every other gun, except Spyders of course!
imahuron
03-07-2003, 09:55 AM
Yes 3/4" between centers. Most (all?) grips accept a #10-32 I believe the nominal size of a 10-32 is .19 (I've found most are just under 6/32 or .1875). Drill a few test holes to find the best bit.
TheJester
03-07-2003, 10:06 AM
i thought they were a 10-32 thread with a 1/2 inch between centers, but it's been a loooooooooong time since i've measured
imahuron
03-07-2003, 10:52 AM
It's 3/4". One can do miraculous things with a tape measure.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.