The "WHOPPER" : Part 2

[PzYcO]

Hey guys, I have two main ideas in mind, and i need your input, vote above about how you want the whopper. The original dimensions of a warp & revvy is about 9-10" high, 3-4" wide....

[nippinout]

Instead of the Warp vertical, why not have it horizontal?

Put the Warp under the loader, then it would be ambidexterous.

[PzYcO]

wont work nippin, the balls would get caught in the tube that is bent, and it would be waaaay too much work ;)

[nerobro]

*drums keyboard* You can't do this with a working warp. the design of the warp rather precludes loading from the side. Unless you run the warp backwards.

as I said earlier, I should have stuff in the next 3 weeks. a smaller warp.. and then the shell is elementry.

[PzYcO]

Actualy it is going to work, just need to finish up the battery pack mod and melt up the hopper

[PsychoBaller]

I am so anticipating Pictures of the prototype.... WORKING prototype at that...

~da baller