View Full Version : The "WHOPPER" : Part 2
PzYcO
03-08-2003, 05:18 PM
Hey guys, I have two main ideas in mind, and i need your input, vote above about how you want the whopper. The original dimensions of a warp & revvy is about 9-10" high, 3-4" wide....
nippinout
03-08-2003, 07:48 PM
Instead of the Warp vertical, why not have it horizontal?
Put the Warp under the loader, then it would be ambidexterous.
PzYcO
03-08-2003, 07:54 PM
wont work nippin, the balls would get caught in the tube that is bent, and it would be waaaay too much work ;)
nerobro
03-08-2003, 10:08 PM
*drums keyboard* You can't do this with a working warp. the design of the warp rather precludes loading from the side. Unless you run the warp backwards.
as I said earlier, I should have stuff in the next 3 weeks. a smaller warp.. and then the shell is elementry.
PzYcO
03-08-2003, 10:12 PM
Actualy it is going to work, just need to finish up the battery pack mod and melt up the hopper
PsychoBaller
03-09-2003, 03:28 AM
I am so anticipating Pictures of the prototype.... WORKING prototype at that...
~da baller
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.