2 questions

[goat]

I have a small (couple 1000th) space between the "body" of my mag and the AIR valve, now at first I thought it might have been due to the fact that the body rail was a little dinked up and that maybe the pin that sticks down off the AIR valve wasnt lining up right, then I realized today that there is no body rail bushing....?? could that have caused this?
also anyone know the thread size for the velocity adjuster,IE what would the thread size be for a tourney lock??
Thanks
Goat

[xen_100]

I had the same problem on the rail bushing. it is a really important part, even if it looks like nothing. get one and your problems will go away.

I have no idea on the second one. you can get tourny locks on-line for like $15..

[goat]

Thanks for the input on the rail bushing until recently I knew nothing about mags-now I know a little more than nothing,.:D
I have access to some machining equipment and want to make a few tourney locks as practice and just because.
thanks again