PDA

View Full Version : Warp problems


Derman2k
03-23-2003, 05:10 PM
The wire that connects the battery to the board ripped off of the battery part...How could I fix this?
Derman2k
03-23-2003, 05:44 PM
Ok...well I have it Ghetto rigged right now and it works. I have electrical tape on the contact and the wire so that they touch...Should I just leave it like that?
warpfeedmod
03-24-2003, 08:50 AM
Originally posted by Derman2k
Ok...well I have it Ghetto rigged right now and it works. I have electrical tape on the contact and the wire so that they touch...Should I just leave it like that?

You're talking about the little 9volt connector that snaps onto the battery? I replaced mine with these from radio shack.

http://www.radioshack.com/product.asp?catalog%5Fname=CTLG&category%5Fname=CTLG%5F005%5F007%5F012%5F000&product%5Fid=270%2D324

these are a heavy duty one that doesn't tear/rip out I've found. Had them in there for about 2 years now and not a problem.
Blazingace
03-24-2003, 10:23 AM
As much as I like AGD they use really crappy wire. I replaced the wire to my motor on one of my Warpfeeds with really good aircraft wire from work. If you are going to be removing your batteries often you should change the connector.