View Full Version : macroline and microline pressure ratings?
thejesus
03-24-2003, 01:21 AM
Hey there,
Does anyone happen to know the maximum gas pressure macroline and microline hoses can handle? I need to re-hose my Micro-RT and of course I'm looking for ways to make it look cooler :)
xen_100
03-24-2003, 01:33 PM
it ussualy says right on the hose.
but then again, it says 500PSI working pressure on the hose I have, and not a problem yet. burst pressure is ussualy 3-4x working pressure.
thejesus
03-24-2003, 03:33 PM
do you have a macroline or microline? I run my RT at 800-900psi is the thing, I like the snappy trigger :)
xen_100
03-24-2003, 03:35 PM
well my preset nitroduck has an output of 850 PSI, haven't has a problem in more than 2 years of use.
Muzikman
03-24-2003, 04:46 PM
The problem is that even if the hose is rated, most (if not all) fitting are not.
Steel braid all the way (and no swivel fittings);)
thejesus
03-25-2003, 12:57 AM
I'll just put one where the hose goes from my vertical asa to the reg :) Thanks for the info guys.
I use macroline on my Spyder and the pressure from the CO2 tank is 800-1000 psi. I have not had any problems with it. If you like to tear your gun apart and add on/take things off, go with macroline.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.