PDA

View Full Version : Fun with paint.


Dubstar112
03-24-2003, 08:33 PM
I took the hopper off of loads sfl, still needs a lot of work, but you can see where im heading..

Well, if you can see, your better than I. Cause I dont know why I did it, other than to see how far I could go.
Dubstar112
03-24-2003, 08:35 PM
how about a single I frame? :) Paint is my favorite program.
HoppysMag
03-24-2003, 08:39 PM
check out my 3d rendering of tom
Load SM5
03-24-2003, 08:42 PM
Give me back my hopper, you tool!:D
FalconGuy016
03-24-2003, 08:44 PM
:)

did you actually take the time to cut the picture out by hand?
Dubstar112
03-24-2003, 09:16 PM
The hopper? No, I just copied the wood grain and went over it by panneling. Then I had to make a fence board from scratch because the hopper blocked part of it, and it was a wierd color, so I went deeper. I get bored somtimes. I have done a couple nice ones. Ill see if I can dig them up. :)
TransMan
03-24-2003, 09:21 PM
U do a lot of barrel taging load?? :D
Load SM5
03-24-2003, 09:29 PM
It's only a 14 inch barrel. The camera angle and the fact that the Edge kits have shorter control bores that most 2 pc barrels make the thing look long.
Dubstar112
03-24-2003, 10:16 PM
Stab somone now! Took me a few to figure out how to make it right, but MSPAINT always comes through