Picture assignment for people with flatlines!

[Skoad]

I need a picture of an overhead or underneath view of the flatline... with the gauges on the right or left side of the reg.

I need to see the space inbetween the gauges and the reg.

Also if you could somehow measure how much space there is between the gauge and the reg that'd be helpful.

ohyea....must be the stock flatline gauges too!

[Skoad]

anyone!? i need pictures before tomorrow!!!

[Gunga]

My the back of my high pressure gauge is .176" out from the regulator body. The low press gauges is .183" out.

It'll vary...just depends how far you have them screwed in.

[Skoad]

ok so, is there a non threaded space? i mean is there just a plain metal space between the back of the gauge and the threads? or is it all threads?

[Will Wood]

How's this? Just had this from a while ago. I can take a new one if you need.


http://www.automags.org/forums/attachment.php?s=&postid=419638
edit^ Image would help :)

[pbguy888]

:)

[Skoad]

if you can, i need the picture from directly underneath, not the side of the reg...like if you were holding your marker and the picture would be from the ground's view upward, but really close to the reg. or if you could just take a picture of the top or bottom of the gauge part

[Russ]

How's this...

[Skoad]

rockin! those are the stock gauges right?

and there is a non-threaded piece inbetween the threads and gauge it looks like

thanks a lot!

[Russ]

Yep, stock gauges, and about 1/16" of "non-threaded" area between the back side of the flange & the threads...

and a 4.5k reg,

[Skoad]

ahh thanks russ, your my hero for the day :)