lordgroom
04-02-2003, 11:24 AM
2 problems-
While removing my trigger frame, body rail, and body a metal washer fell out and I don’t know where it goes. Please help me.
Also. Without that washer when I try to fire my mag it doesn’t fire. I hear a little gas being expelled but the bolt cannot enter the barrel and the bolt is not pushed back to the re-cocked position. When I lift the very end of the barrel, the bolt re-cocks. Maintaining upward pressure on the end of the barrel allows my gun to fire normally. I did replace the o-rings on the barrel, adjusted the barrel twist lock pin upwards and finally installed the metal washer over the barrel adjust pin. The washer in that position worked and the gun fires perfectly except the body does not sit flush in the body rail.
Here is what I have:
Mag classic PF right
Lvl 10
Dye Stainless 10”
Dye 1X trigger frame
Gas through and vert adapter
Running off HPA
Treid to call tech support but no one is available until next week.
While removing my trigger frame, body rail, and body a metal washer fell out and I don’t know where it goes. Please help me.
Also. Without that washer when I try to fire my mag it doesn’t fire. I hear a little gas being expelled but the bolt cannot enter the barrel and the bolt is not pushed back to the re-cocked position. When I lift the very end of the barrel, the bolt re-cocks. Maintaining upward pressure on the end of the barrel allows my gun to fire normally. I did replace the o-rings on the barrel, adjusted the barrel twist lock pin upwards and finally installed the metal washer over the barrel adjust pin. The washer in that position worked and the gun fires perfectly except the body does not sit flush in the body rail.
Here is what I have:
Mag classic PF right
Lvl 10
Dye Stainless 10”
Dye 1X trigger frame
Gas through and vert adapter
Running off HPA
Treid to call tech support but no one is available until next week.