TheTramp
04-02-2003, 11:37 PM
I'm trying to intellifeed my warp from my E-Mag.
I had the correct plug to plug it into the E-Mag board but the wires were cut. I've extend the wires and attached the correct plug to plug it into the Warp.
The problem is that when I plug it in, the Warp runs continuously. I've tried all three positions while the electronics were on and the gun was in e-mode.
1)In the top position it runs all the time.
2)in the middle position it does not run even when I pull the trigger.
3)same as #2 it does not run even when I pull the trigger.
Please let me know what I'm doing wrong and I'll try to answer if I need to clarify anything.
I had the correct plug to plug it into the E-Mag board but the wires were cut. I've extend the wires and attached the correct plug to plug it into the Warp.
The problem is that when I plug it in, the Warp runs continuously. I've tried all three positions while the electronics were on and the gun was in e-mode.
1)In the top position it runs all the time.
2)in the middle position it does not run even when I pull the trigger.
3)same as #2 it does not run even when I pull the trigger.
Please let me know what I'm doing wrong and I'll try to answer if I need to clarify anything.