Gadget
04-03-2003, 10:56 AM
I've got two unused rails at home - one is a standard, genuine AGD mag rail, the other a black Omega rail.
On both I can't get the sear pin to fit - if I hold it by the end I can slide it along the slot so the width doesn't seem to be a problem, but it seems slightly too long to fit into the slot when I go to install it (with or without a sear attached).
I've tried my existing pin (which fits into my current rail no problem) and a new one, both won't fit.
I need to replace my old rail as the z-lock channel is badly worn.
Is this normal? How tight should the sear pin be in the rail? Would it be ok to file the sear pin slot to make it slightly larger, or would I be mucking the tolerances up?
On both I can't get the sear pin to fit - if I hold it by the end I can slide it along the slot so the width doesn't seem to be a problem, but it seems slightly too long to fit into the slot when I go to install it (with or without a sear attached).
I've tried my existing pin (which fits into my current rail no problem) and a new one, both won't fit.
I need to replace my old rail as the z-lock channel is badly worn.
Is this normal? How tight should the sear pin be in the rail? Would it be ok to file the sear pin slot to make it slightly larger, or would I be mucking the tolerances up?