View Full Version : xmag trigger stop
roczilla
04-08-2003, 01:54 AM
is there a way to put a trigger stop on the stock xmag trigger or are there any aftermarket triggers like a blade or such that has stops on them :confused:
CoolHand
04-08-2003, 02:14 AM
Its made from aluminum, therfore it can have a stop put in it.
If you'll send the trigger, and mark the best spot for a set screw to rest on the frame, I will drill, tap, and install a set screw for $15.
Just make sure you mark exactly where you want the set screw, because I will put it right on the mark.
Hope this helps.
HYPER
04-08-2003, 06:11 AM
Man its been a while since Ive been on these boards. Anyways...
Shouldnt there already be a trigger stop on the selector switch assembly? I thought all Emags had them. Just remove the body and adjust the stop from above with a hex wrench.
Either all Emags have them or else my micro-E is just special =).
-Hyper
fire1811
04-08-2003, 07:38 AM
yep take the grip frame off and
ther is a set screw on the top of the trigger.
Make sure you take the pin out of the sear before you try to take body off.
roczilla
04-09-2003, 05:35 AM
thanks i appreciate the input
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.