CCM locking-feeds on ULE

[Python14]

I'm designing my plan for my mag setup and have one question. If I ran a CCM locking-feed on the ULE, would it be better to get the hi-rise or low-rise? I'll be using a retrovalve/12v revy combo so speed is very important.

[RobAGD]

Ditch the Rev get a Halo or Egg2 and get a low rise.

-Robert

[EsPo]

low rise will provide a smaller profile, but from what ive read, a high rise may provide faster feeding due to a bigger ball stack ect.. id go with lo rise. not sure if a CCM clamper will fit.. it will if they make them in angel threads. www.chipleymachine.com

[PzYcO]

get the no rise :)

[persistent]

i just mailed them on this very subject and they said it would be about 4 weeks for the no rises