WickeDKlowN
04-13-2003, 12:58 AM
I was laying on my coulh, holding my 'mag, listening to a Mudvayne, when it hit me. A Plastic Body Rail. It would be pretty light, and im pretty sure it could be done. It dosen't seem like there would be that much stress placed on the body rail, , it just lets the sear pivot, and holds that valve pin thingy in a groove.
Not sure on what type of plastic would be good for it tho. Would have to be strong, and not shatter like glass, Don't think you would have to worry about heat resistance, unless you leave it in the sun for long periods of time. And nothing that would turn yellow over time.
Anyone ever tried this? I know ppl have talked about plastic Bodys, but never heard of a plastic rail.
Well, I'm off to bed. Post your comments and suggestions.
Good Night.
Not sure on what type of plastic would be good for it tho. Would have to be strong, and not shatter like glass, Don't think you would have to worry about heat resistance, unless you leave it in the sun for long periods of time. And nothing that would turn yellow over time.
Anyone ever tried this? I know ppl have talked about plastic Bodys, but never heard of a plastic rail.
Well, I'm off to bed. Post your comments and suggestions.
Good Night.