What is the voltage that should run to the motor off the board of a warp

[thecavemankevin]

I have been haveing some problems with a slow feeding warp, just wondering if that might be part of the problem.

Off of a plainview battery i have
5.90v going to the mottor
9.86v going to the board from the battery

Am i loosing power through the board somewhere?

[thecavemankevin]

anyone? Havoc???

[sniper1rfa]

are you checking the motor voltage when it is running? if so, were you checking the battery voltage when it was running?

[thecavemankevin]

nope, didn't think of that, just tried it and the voltage on the board-from the battery drops don't to around 5.9 or so while running.

Still not sure if something is wrong, she just aint feeding right!

[kdawg]

have you tried a regular 9 volt and test that. What is the MaH of the plainview.....I know 140's don't work in mine, but 150's work great.

[thecavemankevin]

they are 170's

i went ahead and put a new board into it and it seems to be working great now.

any idea as to whats wrong with the other board?