cky shane
04-21-2003, 07:26 PM
Alright, I went through a day playing, emptied most of my tank (down below 1000psi, when it stopped cycling.) All was well and good, I unscrewed the tank, took everything home, and then, for S&G, I screwed it back in and gassed it up. Leaking out the back (not venting) and not even pressurizing the trigger. I took the valve and everything apart, cleaned it all, and no help. Is this a normal thing to happen with low pressure on an RT?
My set-up:
Automag RT Classic
68/4500 CenterFlag Hyperflow (down below 1000psi... pretty sure it was around and below 500.)
Stock barrel
Could it be a bad o ring on the banjo bolt? There's a small knick in the top banjo bolt o ring that I didnt notice, but I don't have a replacement right now (or air to test.) Thanks in advance.
My set-up:
Automag RT Classic
68/4500 CenterFlag Hyperflow (down below 1000psi... pretty sure it was around and below 500.)
Stock barrel
Could it be a bad o ring on the banjo bolt? There's a small knick in the top banjo bolt o ring that I didnt notice, but I don't have a replacement right now (or air to test.) Thanks in advance.