CFD323
05-10-2003, 08:39 PM
I installed my LVL10 last week. I've since fired about 2000 balls through my Emag and it seemed like it was set up just right. Today I went to the field for the first time with the LVL10 installed. It worked fine first game but on the 2nd game I was rolling down the tape line and as soon as I get to the flag station my gun won't fire. It just clicks but nothing comes out. I'm shaking the gun and everything else but no luck. Of course by now I'm seen and promptly shot out. While walking out I shook the gun some more and it started to fire fine. I don't know if a ball got stuck or what. If it got stuck though why didn't the bolt vent and recock ? I did notice the detent was a little loose so I retightened it handtight. I also added another shim and it didn't stick again. Was this the correct solution to the problem ? I don't want it to happen again. After that though, everytime I'd set my gun down between games and then pick it up again the first shot would just click and the gun wouldn't fire. If I pulled the trigger again, it would work fine. Just the first shot after it had sat for a while. Could this be caused by not enough oil in the gun ? I last oiled it a couple of days ago. I probably put 300-400 shots through it yesterday and then another 1000 today. I was going to oil it today before I started playing but forgot. I know the LVL10 is an oil hog but would it cause these problems if not oiled enough ?