View Full Version : A ReTro valve question for Tom
Mr Orange
05-22-2003, 12:55 PM
Tom,
Would I void any warranty or in anyway harm a ReTro valve if I were to polish it so it looked like an A.I.R. valve? I would probably leave the serial numbers on it.
Thanks for your time,
PEACE
LT
la690
05-22-2003, 03:25 PM
its annoed..
yes,
I was under the impresion re annoing, polishing, or anything resembling the above would lead to a voided warrenty?
jb
cphilip
05-22-2003, 06:57 PM
Far as I know its the serial numbers that matter...That and any obvious abuse...
You can't its real hard ano. Burn off the numbers and loose your warrantee.
AGD
It took very high air pressure in order for me to beadblast the anno off my Emag valve. Polishing just won't cut it.
...and yes, all the numbers are gone.
Mr Orange
05-23-2003, 08:00 AM
not even with a dremel? I don't plan on doing it by hand.
Mr Orange
05-23-2003, 08:01 AM
perhaps I should just wait for a platinum x-valve?
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.