PDA

View Full Version : SFL Sear Removal...


rdb123
05-29-2003, 04:08 PM
Hey, I was trying to take out my sear PLUNGER in my SFL Emag. There isn't a C-clip like in regular emags--how do I pull this thing out?

Thanks

-Ron

EDIT: changed it to "sear plunger"
magman007
05-29-2003, 04:15 PM
sear? the sear is removed by the little allen head screw on the side


im assuming you mean sear plunger?
rdb123
05-29-2003, 04:16 PM
Yes, the plunger. ;)

I'm attempting to lengthen my trigger rod so I at least FEEL the reactivity in Hybrid. (My trigger pull with the battery on is about 1mm, but the rod sits about 4mm back from the back of the trigger)
paintballbeaver
05-29-2003, 04:21 PM
sounds like you still have it in e-mode and your trying to get reactiviy out of that ??? when your putting it in hybrid you are just turning it on and leaving it in the m mode right
rdb123
05-29-2003, 04:27 PM
paintballbeaver, yes, of course I'm doing that. ;)

The thing is that sometimes when one or two balling it, I'm in the habit of pressing down on my trigger lightly and having it stop after 1mm of movement (due to using Emode a lot). I'd like the trigger to be kicked back forward in Hybrid where it normally would stop moving back in Emode.
BlackVCG
05-29-2003, 04:31 PM
Just remove the sear axle pin from the side of the body, remove the front frame screw and lift the body off of the frame.

Now, if there's no E-Clip on the solenoid plunger just tilt the sear forward and pull it out. You have to get the trigger rod to clear the inside of the frame to lift it out.
rdb123
05-29-2003, 04:33 PM
Black, I tried that; I started to pull kinda hard on it and it seems like it is still connected.
magman007
05-29-2003, 04:33 PM
the question that is bothering me, is why isnt there a c clip?
BajaBoy
05-29-2003, 04:40 PM
ok well i dunno about your gun, but on my emag i cant pull out, or put it in unless its in mec.

i dunno all the names yet but the wide silver pin (where u adjust the trigger lenth) will show a flat surface towards the sear, and in e-mode its still rounded and doesnt leave enouph room to pull out.

hope you can understand that lol
rdb123
05-29-2003, 05:05 PM
Heh, finally got it out. Now, for the past 10 minutes I've been trying to screw this thing out some, no luck. Any suggestions? ;)

Thanks

-Ron