AutomagBoy
05-30-2003, 02:38 PM
Hey AO im back and doing some more pointless machining, WOOOOO!
I am going to make an Angel threaded feed neck for a warp feed setup. I have the setup and machinery to make this, I just need to help of the AO Elite! I need dimensions accurate to .000 and remeber this needs be as small as it possibly can!. For how high up the threads go the neck needs to point to the right(left models will come later). To keep the neck from twisting more once it pointed right there will be a little ring that goes around right above the threads. well here it is
I need the dimensions for
X1=
X2=
X3=(Internal Diameter, I.D.)
X4=(this is how high up the threads go up the neck)
X5=
X6=(external Diameter, O.D.)
Save it to your hard drive and blow it up some, I know its small.
I am going to make an Angel threaded feed neck for a warp feed setup. I have the setup and machinery to make this, I just need to help of the AO Elite! I need dimensions accurate to .000 and remeber this needs be as small as it possibly can!. For how high up the threads go the neck needs to point to the right(left models will come later). To keep the neck from twisting more once it pointed right there will be a little ring that goes around right above the threads. well here it is
I need the dimensions for
X1=
X2=
X3=(Internal Diameter, I.D.)
X4=(this is how high up the threads go up the neck)
X5=
X6=(external Diameter, O.D.)
Save it to your hard drive and blow it up some, I know its small.