View Full Version : Intellifeed with a hyperframe and my revo...
2UnREal
08-16-2001, 06:32 PM
Can I hook my revolution up to my hyperframe so that each time I pull the trigger the revo spins like a normal intellifeed?
Thanks!
RobAGD
08-16-2001, 10:37 PM
no
-Robert
2UnREal
08-16-2001, 10:37 PM
Thanks.
Threewheeler
01-16-2002, 02:52 AM
Now you've got me curious...
Like 2UnREal, I would like my revvy to keep up with my hyperframe... Why is it that it is impossible to rig the intellifeed wiring into the Hyper.
(Not that I doubt you Rob, I'm just curious.)
Thanks,
Three
Micromag5371
01-16-2002, 02:19 PM
i think if you were to do this you would need a wire from radioshack(not sure which kind) and all you would need to do is cut a little bit of insulation off the negative wire on the trigger switch(i think) and solder a wire going to your revolution. all you do is take shoe-goo (water proof, non sticky gooey stuff at your hobby shop) and dab it around the splice and solder. this will re-insulate it.
i wouldnt advise doing this, because something tells me i am wrong. so if you do it, dont come back and try and flame me.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.