on/off difficulties

[ZAust]

ok, so i got my emag valve, and its going on my classic. i bought this (http://store.airgun.com/acb/showdetl.cfm?&DID=17&Product_ID=131&CATID=6) on/off. now, im assuming that i should use the oring that surrounded the quad oring on the emag on/off on this on/off. however, the on/off wont go down into the valve all the way. it sticks out just a little bit, and this prevents it from going fully into the body. should i oil the oring on the on/off pin? take the oring surrounding it off? please help.

[xen_100]

you shouldn't need a new on/off, just the pin. use a .750 on/off pin in the original on/off assembly and it should work fine.

[ZAust]

so i can use the orignal on/off with the quad oring, as long as i switch out the emag pin with the rt pin?

[xen_100]

I beleive so. I think the only difference between a emag on/off pin and a retro on/off pin is the length. the emag is .712" and the retro is .750"

http://store.airgun.com/acb/showdetl.cfm?&DID=17&Product_ID=132&CATID=6

that is the AGD store to buy replacments.

if I am wrong, I am sure someone will correct me. ;)