X-valve for Micro E-mag Problem

[sherminator]

I just got my x-valve in and installed it in my Micro E-mag. At first I did not change the on/off assembly from the old valve to the new x-valve and the marker shot fine. But, when I changed the on/off assembly like the instructions say for the E-mag, the marker went into rapid fire shoot down.

Is there a problem with the Micro E-mag when changing the on/off? or should I just keep the new on/off assembly in the x-valve?

[Tunaman]

So you are saying that your micro emag shot fine with the stock Xvalve .750 pin? If so...I give up on these Micromags...:(
Could you please do me a favor and measure the pin in the Emicro on/off that was originally in your working gun?

[sherminator]

No problem.

The pin is 0.5 inches