Woogie12
06-12-2003, 07:11 PM
I went out to play today (i have been waiting to get my tank filled and stuff for a week now). I get out there, air up my gun, and load it with paint, and shoot it. It's tough to explain really but here goes. I shoot the first two balls w/ no problems. Then the next ones just roll out of the barrel. It sounds like the bolt isn't pushing hard enough. It sounds weaker than it should be. I believe it could be one of three problems. I was about to cry i was so frustrated.
1)I don't think it's this one but i took the valve off and i noticed that the two sides weren't even. The laser engraved Automag insignia was slanted like a lot.
2)I just got a new worrgames torpedo drop. I don't know if this would change anything but this may be one of the problems.
3) I'm not sure if this happened before or after my murderous rage. Well there is those two holes in the bottom of the valve and one of the holes has something in it that is small and circular and has a rod through it. It was not in the gun and i took of the valve before i played to show my friend how easy my gun is to strip. But i went to put the valve back in the gun after i took it apart cause it wasn't working and noticed that little piece in my bag. Would this be the cause of my problem? I am not sure when it fell out but if it did before i played then that is probably the problem but my macro broke off so i cant test it now.
Please respond fast and thank you for the help.
By the way it's a hopper left powerfeed all stock mag and i got it off of paintballgear.com. Also i put that little piece back in and put co2 in and shot air all through the gun and out the of the body too.
1)I don't think it's this one but i took the valve off and i noticed that the two sides weren't even. The laser engraved Automag insignia was slanted like a lot.
2)I just got a new worrgames torpedo drop. I don't know if this would change anything but this may be one of the problems.
3) I'm not sure if this happened before or after my murderous rage. Well there is those two holes in the bottom of the valve and one of the holes has something in it that is small and circular and has a rod through it. It was not in the gun and i took of the valve before i played to show my friend how easy my gun is to strip. But i went to put the valve back in the gun after i took it apart cause it wasn't working and noticed that little piece in my bag. Would this be the cause of my problem? I am not sure when it fell out but if it did before i played then that is probably the problem but my macro broke off so i cant test it now.
Please respond fast and thank you for the help.
By the way it's a hopper left powerfeed all stock mag and i got it off of paintballgear.com. Also i put that little piece back in and put co2 in and shot air all through the gun and out the of the body too.