View Full Version : Emag leak
Blite
08-24-2001, 07:36 PM
When I gas up my Emag, the bolt sticks. I was told that I should increase the pressure going into the gun, Is this a possible solution? I've already changed the power tube o-ring, and spacer.
a_malfunction
08-24-2001, 09:31 PM
Alright, all you need to gas the gun up quicker. That should do it.
------------------
When in doubt, duck. When certain, don't bother, you're already screwed.
What air system are you using? If it's a screw-in, try depressing the trigger when you screw the tank in.
------------------
Micro E-Mag in Wild Tiger ~ Conquest 88/4500 ~ PTP Warp Feed
Spyder TL+ ~ LP ~ eLCD ~ AGD Flatline ~ Warp Feed
TL+ ~ a few mods
Bob Long Millennium
ICD ThunderCat
BlackVCG
08-25-2001, 01:04 AM
Put the gun in M Mode and hold the trigger when you gas it up, or put a wooden dowel up against the bolt and hold it there when you gas up the gun.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.