View Full Version : foregrip help
prikkaboo
08-24-2001, 05:11 PM
i just bought a kapp dz 2 and it doesnt fit on my micromag because it hits the expansion chamber. if i get a gas through grip will it allow the drop forward to go under it? if i get the proteam products foregrip will that fit? thanks
Load SM5
08-24-2001, 05:18 PM
I had a micro and had the same problem with a gas through grip. I could'nt see getting a new grip helping so I actually cut the DZ bar off close to where it hit the grip. I did'nt use it anyway.
------------------
Black vert.feed E-mag
68/4500 Dynaflow
12" Freak
a_malfunction
08-24-2001, 09:36 PM
If it is a close fit, you could try getting some sort of spacer inbetween the grip frame and the drop. You could try this spacer right here: http://www.nwpaintballproducts.com
It has a quick disconnect type feature on it.
------------------
When in doubt, duck. When certain, don't bother, you're already screwed.
FeelTheRT
08-25-2001, 11:32 PM
get a KAPP forgrip extender.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.