e21bgl
06-14-2003, 04:55 PM
My old 68 Automag - velocity adjustment screw in too far in even a tourney cap could not attached the thread. What's wrong. I've changed a new spring pack assembly + all new parts kits, but it doesn't help. Could someone give me an advise?
By the way, my Mag still shoots well but some time it shoots down while rapid fire. All the parts are stock , no after market parts were modified.
I uses Co2 source + Palmer regulator because in Thailand , compressed air is too expensive and hard to find Paintball fields/stores that available for HPA system.
Any suggestions would be helpfull for me. Thanks.
Beau
68 Automag # CF 31188
STB Palmer pursuit regulator
12" Palmer's ported barrel , DYE 14" Stainless Steel
By the way, my Mag still shoots well but some time it shoots down while rapid fire. All the parts are stock , no after market parts were modified.
I uses Co2 source + Palmer regulator because in Thailand , compressed air is too expensive and hard to find Paintball fields/stores that available for HPA system.
Any suggestions would be helpfull for me. Thanks.
Beau
68 Automag # CF 31188
STB Palmer pursuit regulator
12" Palmer's ported barrel , DYE 14" Stainless Steel