Star_Base_CGI
06-16-2003, 01:50 PM
I cant tell my friend warped, to cut up perfectly good stuff if I am not willing to do it myself.
I cut half an inch off my feed tube to lower it half an inch. (Little more than I would have liked.)
I also big celled Moded my Warp. I ran the batteries in Parallel. Remeber that at 18 volts it will fry the board SO DO NOT RUN THEM IN SERIES!
There is a lip inside the warp. I drilled holes in it and Hung my battery wires through that. SO they do not break off my PCB board.
I cut half an inch off my feed tube to lower it half an inch. (Little more than I would have liked.)
I also big celled Moded my Warp. I ran the batteries in Parallel. Remeber that at 18 volts it will fry the board SO DO NOT RUN THEM IN SERIES!
There is a lip inside the warp. I drilled holes in it and Hung my battery wires through that. SO they do not break off my PCB board.