PDA

View Full Version : project spyder board


314159
06-29-2003, 08:41 PM
just a little something i have been messin with, probally more of a writeup later, but the mosfet is large enough to throw an ebay solenoid ;)

http://www.speakeasy.org/~aaronw/rev3.jpg

http://www.speakeasy.org/~aaronw/rev3n1.jpg

http://www.speakeasy.org/~aaronw/rev3n2.jpg

http://www.speakeasy.org/~aaronw/rev3n3.jpg

http://www.speakeasy.org/~aaronw/rev3n4.jpg

http://www.speakeasy.org/~aaronw/rev3n5.jpg
robertjuric
06-30-2003, 12:57 AM
Lookin good, any specs? Check your pm's.
WickeDKlowN
06-30-2003, 02:55 AM
Give us some specs on it
314159
06-30-2003, 08:33 AM
there are no physical specs, i can program the controller to do whatever i want hehe. this is kinda a stepping stone to the final version. basicly an upgrade from a board limited to 13 bps.... the idea is to make the limiting point the spyder hardware.
Matt_mg
06-30-2003, 10:52 AM
as for specs I think he meant the specs for the electronics...

Are you using two batteries for the setup or am I mistaken?
314159
06-30-2003, 11:17 AM
1 battery, 9 volt, can run it at 6-30vdc input, mosfet can switch the solenoid in the input voltage range+, at 14 amps. are the basic specs.