X Valve problems

[Greg Smith]

Ok, I'm not sure if this is an RT problem or a Level ten problem, but my bolt is sticking. It usually works fine when I pull the trigger at a slow rate, but when I speed up it starts to stick. Any suggestions to what might cause this? The vave is new (I've shot maybe 2 cases through it). I have used a little shocker grease on the inside of the bolt. I have the input pressure set at around 750 psi.

[Dayspring]

Try moving up a 1/2 size on your carrier.

Also, make sure you run oil through your air lines.

[S.S Bandit1]

I had a similar problem but once I took out the on/off pin and ran oil through my valve it starting working great...