Hyperframe

[ChuckWag78]

I'm looking into getting a hyperframe and just want to know a few things first.

Will it work with the X-valve?
Do I need to change the on/off? Will That effect the X-Valve in anyway?

Basically I don't know much about them and I want to know what I'm getting my self into;)

[automagking182]

Yes they will work with an x-valve, yes you need to replace the on/off with the centerflag on/off which isnt hard at all to do, and no it will not effect the x-valve in any. No extra wear or anything.

[automagking182]

O ya my advice would be to get one, they are so worth it.

[Digits]

^^

what he said.. There so much fun :D

[ChuckWag78]

What if I don't have the centerflag on/off? Can I get one somewhere? Can I use the X-Valve one?

[Digits]

^^

If it doesnt come with the on/off just phone them and ask for one.. Mine came with the on/off but I bought it used, so I dunno.

[GhillieGuy]

Actually according to the centerflag instructions for the hyperframe you can use the rt on/off assm. but you have to put the centerflag on/off o-ring on it and the centerflag pin. Free from centerflag if you have the serial #.

[ChuckWag78]

Where is the Serial#?

[GhillieGuy]

Right above the push buttons where is says S#********whatever...

[ChuckWag78]

thanks

[ChuckWag78]

Ok so I got a Hyperframe(It's in the mail), but I didn't get a Centerflag on/off with it. As I said before I have an X-Valve. Should I try to get a centerflag on/off? Either by calling Centerflag or looking around the forums. Is it bad for the frame or the valve to use the stock xvalve on/off? Thanks for all your imput.


SOON I WILL HAVE A HYPERMAG!!!!!!:D :D

[ChuckWag78]

UP!

[automagking182]

its not bad for you to use the standerd x-valve on/off, but it wont work. the on/off pin is not long enough. so yes your best bet would be to contact centerflag and get the right sized pin and o-ring for the hyperframe (this is wat i did). good luck