PDA

View Full Version : hot to put x valve in microemag


MicroEmag
07-21-2003, 09:01 PM
hey i was wondering what i need to do to switch my xvalve into my micro emag
Thx
Dayspring
07-21-2003, 09:59 PM
Save the on/off assembly. Put Xvalve in.

Done.

:)

(You may need to tune the level 10, you may not.)
MicroEmag
07-21-2003, 10:25 PM
hrmm feeling very dum today where is on/off located
thx again
yurchikcs
07-21-2003, 10:30 PM
Inside the valve. Pull the valve from the gun, flip it upside down, and it will be right there sticking out the bottom. It's were the sear pushes against.
Dayspring
07-21-2003, 11:08 PM
Take the little pin inside it too.
ignatz
07-22-2003, 03:38 PM
MicroEMag - If you bring your marker out to Paintball Experience this weekend, I'll show you how to do it if you like. Specifcially, the parts you're interested in are the on/off pin and the quad-oring from your Micro E valve. Take a look at the diagram: here (http://www.airgun.com/downloads/retroexploded1.pdf) Trade those two pieces with the X's and you'll be in business.
MicroEmag
07-22-2003, 11:42 PM
allright i think im done except lnow you tell me i need a different o ring witch is the quad oring??
ignatz
07-23-2003, 08:05 AM
If you are simply upgrading a Micro EMag valve to a X Valve, you shouldn't need any new parts. If you don't have the old valve, you will need 2 parts a> a PTP Micro EMag on/off pin (The MicroE's on/off pin is a different length that the normal EMag's) and b> a quad o-ring (http://store.airgun.com/acb/showdetl.cfm?&DID=17&Product_ID=233&CATID=6). (In the exploded RT Valve diagram, the o-ring on top of the on/off assembly is typical but the E's require a slightly different oring.) Did I answer your question?