View Full Version : Emag and warp feed
JT2002
07-28-2003, 08:44 AM
anyone know where i can find info (or u can just post what you know here) on intellifeeding an emag to a warp, and how to run the warp off the emag battery?
scarpa43
07-28-2003, 09:59 AM
I do not know about the running the warp of the battery, but AGD sells a cable that plugs into the Emag board and then into the warp to intellifeed it.
I have used it on my Emag and basically everytime the Emag board gets a signal from the trigger pull it will spin the warp according to how you have it set up.
Here is the cable in the AGD store:
http://store.airgun.com/acb/showdetl.cfm?&DID=17&Product_ID=83&CATID=6
JT2002
07-28-2003, 10:21 AM
does anyone know if there is a place where i can buy the little plastic connector? and btw how long is that cable? because i do have a wire from my timmy thats being traded today, that was used to intellifeed the warp with my timmy.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.