View Full Version : Hopper to Warp Connection
jpdgas
07-28-2003, 01:16 PM
Im using a revy with my warp and Im having problems keeping it on there. The neck is just small enough to not fit in the warp snug. I tried electric tape (cause thats all i had at the field) and it kinda worked, but i want a permanent solution. what do you guys use?
Dayspring
07-28-2003, 01:59 PM
Dye makes a feedneck spacer. You insert it into the Revvy feedneck and then put the Revvy in the Warp. Works like a charm.
the larch
07-30-2003, 03:37 PM
the easiest thing to do is to back the screws out of your warp a bit so that there is a slight gap betweent the halves, then wrap enough tape on the neck of your loader so that it is a tight fit. Then, tighten the screws back down with he loader in place. Very cheap, very easy and no increased profile.
the larch
07-30-2003, 03:39 PM
the easiest thing to do is to back the screws out of your warp a bit so that their is a slight gap betweent the halves, then wrap enough tape on the neck of your loader so that it is a tight fit. Then, tighten the screws back down with he loader in place. Very cheap, very easy and no increased profile.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.