PDA

View Full Version : x valved micro mag


sbpyro
08-14-2003, 07:41 AM
Will I be able to put the x valve into a micromag ??
JEDI
08-14-2003, 07:52 AM
Yes. It will fit.
wyn1370
08-14-2003, 07:58 AM
might have to play around with the on/off pin though
sbpyro
08-14-2003, 08:29 AM
Originally posted by wyn1370
might have to play around with the on/off pin though

Okay I'll byte why do i have to play with the on/off
wyn1370
08-14-2003, 08:42 AM
Originally posted by sbpyro


Okay I'll byte why do i have to play with the on/off
As far as PTP goes, they don't use the same spec pin as other E's, not sure about non-E's. If I remember correctly, they might even custom trim each pin to make the specific micro work. Might want to hold onto the on/off pin that is currently in the micro you've got just in case.
FalconGuy016
08-14-2003, 08:43 AM
Yes, just keep your pin. If the xvalve doesnt work, go for the old one
sbpyro
08-14-2003, 08:50 AM
Originally posted by wyn1370

As far as PTP goes, they don't use the same spec pin as other E's, not sure about non-E's. If I remember correctly, they might even custom trim each pin to make the specific micro work. Might want to hold onto the on/off pin that is currently in the micro you've got just in case.

So this is in regards to the on/off pin for emags being different. I don't think that would be a problem since it isn't a microemag. It is an old micro mag (no e or rt on it)but I will keep the on/off assembly jic.
wyn1370
08-14-2003, 09:17 AM
you don't need the whole assembly, just the pin