NW Quick Disconnect Block

[Derman2k]

I got one of these in the mail today for my Emag and when I put the drop and warp on it wobbles...Any fixes? I even tried putting electrical tape on the top and that didn't help

[deathstalker]

Gotta start with the obvious... you did tighten the the screw in the back, right? I've never had a problem with mine, but I think the wobble has been an issue with others.

That's why Datapimp made his!

[Derman2k]

Yea...I think it might be the pin...like it seems too small to make a tight fit

[Wynken]

I think it's supposed to be wobbly until you screw in the wing nut in the back. That's supposed to take the slack out. At least, that's how it worked on the 3 or 4 I've seen.

[Derman2k]

Tightened til i can't tighten no more...and still wobbly

[oneshot]

you might want to check how tight the block is in to the gun. that is the only thing that sometimes comes loose. I have them on all four of my guns these things rock.

[Derman2k]

The part on the grip doesn't wobble, its the other part...the one that slides in that wobbles

[ChuckWag78]

Make sure the bottom part of the block(The part that attaches to the drop) is tighted down on the drop good. This is one of those things where tightening down to much is ok. I have two and they both rock!

[FooTemps]

Mine wobbles because my cf grip is screwed up, try tightening everything.

[Derman2k]

I just had to use a wrench on the wing nut and it doesn't wobble anymore. Thanks everyone.

[AlabamaMan]

I have two of them, and have nver need to use a wrench on the wing nut. That is weird. But i did have the bottom block come loose from my drop after about 30k shots on my emag.