Bossman
08-18-2003, 07:44 PM
I have an early build rt classic "00520", after examining the sear assembly I noticed that the trigger rod must have been adjusted at some point.
Id like to know if the length from tip to pivot arm back is 1.980", all reference I've found says this but Im just double checking.
also, for the same valve as above, What is the proper length on/off pin? Mine measures .751.
I noticed on the AGD store that they sell an "RT" pin thas .728, should I be using this pin?
Please keep in mind, this gun was bought used and Im assuming Its been tampered with.
Thanks for your help.
GENO
Id like to know if the length from tip to pivot arm back is 1.980", all reference I've found says this but Im just double checking.
also, for the same valve as above, What is the proper length on/off pin? Mine measures .751.
I noticed on the AGD store that they sell an "RT" pin thas .728, should I be using this pin?
Please keep in mind, this gun was bought used and Im assuming Its been tampered with.
Thanks for your help.
GENO