1. Use the Biggest carrier that doesn't leak.
2. Use as little shims as you can get away with.
3. If you lose your bolt foamie, replace it.(see Problems section)
4. As soon as your bolt bumper begins to wear, replace it.
5. When first installing a level 10 kit, shoot as much as possible(take advantage of that all day air) It takes a good while to break in a new o'ring.
6. Use the middle spring whenever possible.
7. If you have to chrono down below 270 and your no longer getting a reliable pull, use a longer ported barrel before changing your level 10 settings. If you must, switch to the stock brass spring.
8. When switching carriers, use the same O'ring.
9. When using a cut spring, cut side ALWAYS goes on the bolt.
10. Always make sure that the carrier is fully in the powertube before putting in shims.
11. Make sure shims are not bent.
12. Dont over tighten the powertube tip.
13. Do not oil the inner carrier o'ring directly as it will cause a false sense of friction which will give you problems once that oil is gone.
14. The field strip screw is the perfect tool for removing a carrier from the powertube. Give it a few turns and tug, dont worry it wont damage the o'ring.
vBulletin Message