Well less of a tech question but here goes. Has anyone had their on/off pin brake?
I don't mean ware down or bend. I mean SNAP IN HALF, played with the Emag this weekend the RT Pro valve aired up fine, I pull the trigger and nothing. Pull the panel of the sear is lose and moving fine, but still no joy. Switch the RT for the X and she is off and running then i notice a piece of metal stuck to the trigger magnet.
This was a NEW .728 pin from AGD not filed or ground down at all.
I don't mean ware down or bend. I mean SNAP IN HALF, played with the Emag this weekend the RT Pro valve aired up fine, I pull the trigger and nothing. Pull the panel of the sear is lose and moving fine, but still no joy. Switch the RT for the X and she is off and running then i notice a piece of metal stuck to the trigger magnet.
This was a NEW .728 pin from AGD not filed or ground down at all.