I bought an used RT mag. Unfortunately i don't have with me the serial number of the valve, but i think it is one of the first series of RT, not an RT pro.
The valve is leaking, and i was told by the previous owner that it was due to some washers missing from the pin assembly.
I checked the exploded diagram for the retro valve and i think that this diagram refers to a newer valve. When the owner showed the pin assemble to me, he had the reg seat and the reg holder assembled in the front of the pin (i.e. - towards the on-off assembly) and several washers towards the back of the pin. The diagram has the reg seat and holder towards the back of the gun and no washers whatsoever.
Is this pin assembeld correctly or is this the cause of failure?
If i replace the pin with a new one would it fit the valve or should i upgrade it?
thanks. i will put the SN soon.
The valve is leaking, and i was told by the previous owner that it was due to some washers missing from the pin assembly.
I checked the exploded diagram for the retro valve and i think that this diagram refers to a newer valve. When the owner showed the pin assemble to me, he had the reg seat and the reg holder assembled in the front of the pin (i.e. - towards the on-off assembly) and several washers towards the back of the pin. The diagram has the reg seat and holder towards the back of the gun and no washers whatsoever.
Is this pin assembeld correctly or is this the cause of failure?
If i replace the pin with a new one would it fit the valve or should i upgrade it?
thanks. i will put the SN soon.