hello guys...
as i am sorta strapped for cash... i want to do this mod myself...
i have access to all the tools.
and as far as i know... these materials are needed
2 9v batt connectors.
some heatshrink
1 switch
solder/soldering iron
drill (for switch)
and some brains...
if you have done this b4...
can you tell me how everything was taken apart? like the board and all? cause the board is also attached to the motor.
i will connect the adapters like so in the picture... the black wires will be stuck together while the red is going to the switch... do i have another wire from the switch going onto the board? and the black onto the board too?
i just dont want to fry the board... and want to make sure before i go do an operation on my gun.
if anybody can verify this for me it will be greatly appreciated...
thx.
eryk
as i am sorta strapped for cash... i want to do this mod myself...
i have access to all the tools.
and as far as i know... these materials are needed
2 9v batt connectors.
some heatshrink
1 switch
solder/soldering iron
drill (for switch)
and some brains...
if you have done this b4...
can you tell me how everything was taken apart? like the board and all? cause the board is also attached to the motor.
i will connect the adapters like so in the picture... the black wires will be stuck together while the red is going to the switch... do i have another wire from the switch going onto the board? and the black onto the board too?
i just dont want to fry the board... and want to make sure before i go do an operation on my gun.
if anybody can verify this for me it will be greatly appreciated...
thx.
eryk