im wiring up my intelli to rev setup tonite. its going great. i put a submini jack in the rev, looks nice. i wire up the roller switch. im soldering everything nicey nice. it all works great. im putting the shell together and of course the lid spring goes flying. i put down everything real fast to go find the spring. im on the floor in my workshop with a flashlight and then i smell the burning plastic. i put a shell half too close to the soldering iron. doh!. the half without the guts. ist ruined. i burned the lid mount hole area. f.u.b.a.r
just got done ordering a new xboard rev. good news is i have a set of intellifeed guts wired and ready to go.
since i was in the buying mood i also picked up a new reds pack, 4 140 tubes, a new flex 7 thermal, a mag parts kit and reg piston.
just got done ordering a new xboard rev. good news is i have a set of intellifeed guts wired and ready to go.
since i was in the buying mood i also picked up a new reds pack, 4 140 tubes, a new flex 7 thermal, a mag parts kit and reg piston.