Printable View
Ok, still learning my mag symptoms,
Just rebuilt my x valve with a kit from agd
Now I have a leak down the barrel. The leak almost goes all the way away when I pull the trigger but it is not firing either
What did I do
Sent from my Moto Z (2) using Tapatalk
If it's leaking down the barrel, try a different o-ring in the carrier. As far as I know, some o-rings fit better than others, experimentation will be required. Did you pull apart the rear half of the reg when you were cleaning and replacing stuff? If you didn't screw it in far enough, there won't be enough pressure for it to fire.
Sent from my SM-G970U using Tapatalk
Remove the L10 carrier and any shims
Fit the carrier on the bolt stem and see how snug it is. It must be snug...not tight or loose. Tighter is better here
lay out all your L10 carriers in order of size.
If the oring is too tight or too loose, remove it and try it in another carrier until you get it right. You should be just able to shake the bolt from the carrier while dangling it. Do not damage the oring while removing it.
Let us know if you need more
Put your bolt on, hold onto to the entire valve assembly by the bolt. The valve shouldn't slide down easily at all. It should hold. If it slides go to the next smaller size. If it doesn't budge, could be right or could be too small.
Sent from my SM-N960U1 using Tapatalk
Ok, new problem
No more leak down the barrel but I feel like I'm going backwards
Air it up, trigger rod comes forward, pull the trigger and nothing. No firing, trigger rod stays back and does not reset unless I degas the marker and gas it up again
Ugggg, I feel like I'm so close and so far at the same time
Attached photo, see if anything looks out of placehttps://uploads.tapatalk-cdn.com/202...b6ae16e471.jpg
Sent from my Moto Z (2) using Tapatalk
You cant put that reg pin in all together like that. And dont pull them out all together either. Install the pin, then the reg seat oring, then the reg seat holder. Small oring stays in the back half like you have it. Make sure to crank up velocity using 1/2 turns until it clicks. Let us know.Quote:
Originally Posted by trbo323
Hmmm, progress. I think I had the reg way too low, after reassembling it like you said and cranking up quite a bit I got it to start shooting but it will only fire at very low rates of fire and is not always resetting after the shot. The trigger rod stays back rather than coming forward
Sent from my Moto Z (2) using Tapatalk
what is your input pressure? must be at least 800 psi.
Try tightening the field strip screw with the wrenchQuote:
Originally Posted by trbo323
Just putting this photo herehttps://uploads.tapatalk-cdn.com/202...87a75f4786.jpg
Sent from my Moto Z (2) using Tapatalk
Did it work?Quote:
Originally Posted by trbo323