Sold!
Sold!
max flow works?
yes, I tested it out on my mag and got it to RT at different pressures before I took it off. I think there was a slight leak at the on/off, new o-rings would probably fix that.Quote:
Originally Posted by knownothingmags
Take 40$for it?
Sent from my SM-G930V using Tapatalk
I can do $45, I can't go any lower because shipping is going to cost me at least $10.Quote:
Originally Posted by knownothingmags
Thankyou for the counter offer but I'll have to passQuote:
Originally Posted by hathegkla
Sent from my SM-G930V using Tapatalk
Do you have a rebuild diagram for the reg? I'm curious about the design before I decide if I'm interested. Is this the MF-I reg?
I'll check on that when I get home. I still have the original box so it should have the exact model info. I know it comes with an extra spring for low and high pressure.Quote:
Originally Posted by luke
So is it a preset high or low or is it adjustable in those ranges?
it's adjustable within those ranges, you just turn the end cap to adjust pressure. I don't know a lot about it but it has a high and low pressure spring. I ran it over 800psi with the high pressure but I'm not sure what the limit is. I might even have the manual, I will check.Quote:
Originally Posted by luke
ZDSPD has a full write-up on his site.Quote:
Originally Posted by luke
http://www.zdspb.com/tech/mguide/regs/main_inline.html
As for the output psi, if it's anything like the other Max-Flo regulators, each spring give you a different range. If you install the low pressure spring, then you use the front knob to adjust from 0-500 psi, or something like that. Or you can use the high pressure spring to adjust from 500-1000.
You can actually also use the high pressure spring for lower pressures than 500, but it's harder to get precision adjustments in those ranges.
Yeah, o-rings should fix that, but can you tell us if this regulator bleeds when shut off? If it doesn't, then it can be really hard to remove the air lines after turning the air off....unless the on/off leaks out the pressure.Quote:
Originally Posted by hathegkla
I've already imported that ZDSPD file, my CAD program had fits with it so I haven't fully explored it. lol
I'm not sure if it does. I think I just turned the tank off and fired a shot before I removed the air line. the tank is empty at this point anyway.Quote:
Originally Posted by rawbutter
EDIT: I updated the pictures and added the box info.
Ill take the Max Flo if still available
Sent from my LG-H901 using Tapatalk
(I'm not in line)
those on/offs are notorious for leaking in the inline maxflos btw.
Pming
Pm'ed again let me know if you aren't getting them please. I am interested in getting this.
-Duncan