Printable View
I cannot seem to get my warped feed to work, I am shooting a classic mag with the Retro Valve.
I have set the jumpers on the warp to "sen" so that it reacts to vibrattion. I have also set the potentiometer just back from where it runs all the time. When I shoot my marker with no paint the warped will work, but upon adding paint, it is a dead dog.
I am at a loss here.??
Prezents
that is odd. Ususally on an AutomaG, it would spin even if u had the sensitivity to the lowest.
Try replacing the battery with a high quality brand name one. We have seen problems with batteries that sell at a discount and are underpowered.
AGD
Also make sure the paint is feeind smoothly. I cannot use blaze in my warp b/c it swells so fast and wont fit in the 90* adapter. This will cause a jam and it wont spin. Look at the motor while you hold down the purge button. If you see it spin inside the motor but it doesnt move then it's b/c it's jammed. These are my expereinces, it happens to me all the time and pisses me off. Check that with a fresh battery i feel that thats the problem!!!
I have tried 4 new batt's not the cheap one's either, learned that in Winnitt.
Let me work on this a little more with a different brand of paint
Prezents
This same problem happened to me, add paint and it dies. You potentially have a cracked sensor. Thats what mine was.
This has been going on since I recived the Warp.
Prezents
You might have to send it in. Call us.
AGD