lol, im starting to feel like dirty bunny Can someone help me out here?
got an xvalve for xmas. I hooked it up at first, without oiling anything or doing anything. I gassed it up, and i didnt get any pressure from the on/off and hence the trigger didnt get any pressure. I unscrewed the tank and posted to see waht to do. Some one said put the velocity up. I gassed it up, put up the velocity, and nothing happened. I took the gun apart, and the body was stuck to the valve because the valve had retained the pressure somehow. I pushed the on/off pin a bit and the gun valve cycled, which caused me to drop it, and the on/off assy came out, and i lost the small oring that belongs on top of the on/off assy, and grease was everywhere. I gassed the gun up without the small oring and oiled the on/off assy. The trigger got some pressure, but it wouldnt shoot. I took out the valve and left it alone until today. I planned on buying an oring kit to replace that oring, but instead, today i bought a ult kit. I took out the one oring that was in the on/off assy hole, and put in the ult. Same thing happened, the trigger didnt get any pressure. I don't wanna mess anything up now, so what should i do to make it work?
I pm'ed cphil asking for help. He told me to oil the ult and add 2 spacers. I did, when i screwed it back in it didnt tighten up too much, is it supposed to spin freely? I put it back in and the same thing happened, no pressure going to the trigger. This sucks