I recently purchased an RT pro valve to upgrade my mag. When I installed the RT and turned on the HPA the gun instantly began to rapid fire without me pulling the trigger. I tried shortening the trigger rod but I got rapid fire again... any ideas?
Registered User
I recently purchased an RT pro valve to upgrade my mag. When I installed the RT and turned on the HPA the gun instantly began to rapid fire without me pulling the trigger. I tried shortening the trigger rod but I got rapid fire again... any ideas?
Registered Useless
Check the On/Off o-rings and make sure the on/off pin is the correct length.
U R techno-literate!
Which on/off does it have?
Make sure the field strip screw is at least snug.
Registered User
It looks like an RT on/off, all the o-rings are good. The on/off pin may be too short, I don't have anything to accurately measure it. On the skinny end it seems to have been ground down or broken off, it isn't smooth on the end.
U R techno-literate!
Good ruler?
The stock pin should be right at .750 (3/4").
A short pin will be more than 1/32" shorter.
Anyone know if you can drop a quad o-ring into an RT Pro on/off cavity?
Registered User
This pin measures just under 1/2 inch, it must be my issue.
U R techno-literate!
Originally Posted by Wilson!
That's pretty much like not having a pin...
Registered User
Thanks for the info!
PrestonCoPaintball
evidently sir , you have a broken pin
Posting Permissions
Reply With Quote